Subscribe to:
Posts (Atom)
Tamco
.jpg){kind=logo}
About Me
- Tamco a Division of Barney Family Enterprises LLC
- Tamco manufacturers the finest auto/marine and OEM coatings available with distributors throughout the country; as well as private labels for many top named companies! Started and still operated by The Barney Family since 1989
9040 Series Duraflint 1
ReplyDeletePOLYURETHANE ENAMEL SYSTEM 3:1:(1)
FEATURES:
> Easy to apply metallic colors
> Outstanding gloss
> Superior flow-out and leveling
> Outstanding durability
> Excellent gloss & color retention
> Economical to use
MIX RATIO:
--3 parts Polyurethane color
--1 part HH-50 Standard High Solids hardener (or HH7603 Fast, HH-7605- Medium, HH-7607 Slow)
--up to-1 part HH-Reducer (Metallic colors especially)
SURFACE PREPARATION:
Bare Metal:
> Wash surface of vehicle with soap and water to remove tree sap and road dirt
> Wipe vehicle with wax & grease remover.
> Sand area as necessary to remove any rust or corrosion
> Prime repaired areas with HH-5310 or 5311 2K urethane primer
> Block primed body work with 400 grit or finer wet or dry sandpaper
> Cleanse area to be painted with wax & grease remover
> Seal vehicle using HP-6001 universal sealer
Pre-painted Surfaces:
> Wash area to be painted with mild detergent and water
> Cleanse surface with wax & grease remover
> Sand area as needed to remove old paint or any rust using 320 grit D.A.
> Apply one full wet coat of HP-6001 universal sealer.
> Allow Sealer 30 minutes dry time before topcoat.
V.O.C. INFORMATION:
Urethane color V.O.C.: <569 gll (4.75 #/gal)
.- Less exempt solvent V.O.C.: <569 gll (4.75 #/gal)
Mixed product V.O.C.: <599 g/I (5.0 #/gal)
This product may require several components and must be mixed properly to comply with
V. O. C. regulations. This product is not recommended as part of a multi-coat system if the
V. O. C. exceeds local, state or Federal regulations.
POLYURETHANE SYSTEM APPLICATION DIRECTIONS:
> Adjust HVLP air pressure to 30 psi at the gun
> Apply 2 Full wet coats of Polyurethane Enamel color
> Allow 10-15 minutes flash time between color coats
> Allow vehicle to dry overnight before exposing to weather or finessing
APPLICATION INSTRUCTIONS: Intregrating clear (USE ONLY HC-9040 Clear!)
> Apply two wets coats polyurethane color per directions
> Add 1 part catalyzed color 1 part catalyzed HC-9040 clear & mix.
> Allow 20 minutes flash time before topcoat
> Apply 1 wet coat blended color / clear
> Allow overnight dry
DryTimes @ 75F
> Dust free – 20-30 minutes
> Tack free - 3-4 hours
> Tape free – 12 hrs.
> Delivery - overnight
For maximum paint performance, vehicle should be kept above 75°F. Temperatures
below 60°F will severely retard dry times and thorough cure of urethanes.
1 ounce of TAMCURE Accelerator per mixed gallon may be added to speed up
cure.
CLEANING
Clean equipment with a quality lacquer thinner.
Do not leave catalyzed paint in the gun more than 4 hours.
TECHNICAL DATA:
PRODUCT SAFETY INFORMATION:
Consult Material Safety Data Sheet
www.tamcopaint.com
a BFE company